External link to Solved > 2. The sum of the ohmic resistances of:2053898 …

# Solved > 2. The sum of the ohmic resistances of:2053898 …

2. The sum of the ohmic resistances of a diode is called the ideal resistance. 3. The maximum forward current is one of the maximum ratings given on a data sheet. 4. An ideal diode acts like a switch that closes when forward-biased and opens when reverse-biased. 5. You can quickly check the condition of a diode with an ohmmeter on a high resistance range. […]

External link to Solved > PROBLEM 15.1 A saturated solution containing 1500 kg:1738347 …

# Solved > PROBLEM 15.1 A saturated solution containing 1500 kg:1738347 …

PROBLEM 15.1 A saturated solution containing 1500 kg of potassium chloride at 360 K is cooled in an open tank to 290 K. If the density of the solution is 1200 kg/m3, the solubility of potassium chloride/100 parts of water by mass is 53.55 at 360 K and 34.5 at 290 K calculate: (a)the capacity of the tank required, and (b)the mass of crystals obtained, […]

External link to Solved > 4-58. Determine the minimum cable force T and:2016643 …

# Solved > 4-58. Determine the minimum cable force T and:2016643 …

4-58. Determine the minimum cable force T and critical angle which will cause the tow truck to start tipping, i.e., for the normal reaction at A to be zero. Assume that the truck is braked and will not slip at B. The truck has a total mass of 4 Mg and mass center at G.x 4-59. The thin rod of length l is supported by […]

External link to Solved > 13-83. The steel bracket is used to connect:2018232 …

# Solved > 13-83. The steel bracket is used to connect:2018232 …

13-83. The steel bracket is used to connect the ends of two cables. If the applied  force P= 500 N, determine the  maximum normal stress in the bracket. The bracket has a thickness of 0.5 cm and a width of o0.75 cm. 13-84.  The wide-flange is subjected to the loading shown. Determine the state of stress at points A and B, and show the results […]

External link to Solved > 7–21. The supporting wheel on a scaffold is:2017186 …

# Solved > 7–21. The supporting wheel on a scaffold is:2017186 …

7–21. The supporting wheel on a scaffold is held in place on the leg using a 4-mm-diameter pin as shown. If the wheel is subjected to a normal force of 3 kN, determine the average shear stress developed in the pin. Neglect friction between the inner scaffold puller leg and the tube used on the wheel. GraduateWriterHelp.com is an online academic writing platform that provides […]

External link to Solved > PROBLEM 10.8 In the production of caustic soda:1738267 …

# Solved > PROBLEM 10.8 In the production of caustic soda:1738267 …

PROBLEM 10.8 In the production of caustic soda by the action of calcium hydroxide on sodium carbonate, 1 kg/s of sodium carbonate is treated with the theoretical quantity of lime. The sodium carbonate is made up as a 20 per cent solution. The material from the extractors is fed to a countercurrent washing system where it is treated with 2 kg/s of clean water. The […]

External link to Solved > 15–1. The simply supported beam is made of:2018327 …

# Solved > 15–1. The simply supported beam is made of:2018327 …

15–1. The simply supported beam is made of timber that has an allowable bending stress of ? allow =6.5 MPa and an allowable shear stress of ? allow = 500lPa. Determine its dimensions if it is to be rectangular and have a height-towidth ratio of 1.25.     GraduateWriterHelp.com is an online academic writing platform that provides extensive assistance to graduate school students as they […]

External link to Solved > EXAMPLE 11 .7 A balanced three-phase Source serves:2030322 …

# Solved > EXAMPLE 11 .7 A balanced three-phase Source serves:2030322 …

EXAMPLE 11 .7 A balanced three–phase Source serves three loads as follows: Load I: 24 kW at 0.6 lagging power factor Load 2: 10 kW al unity power factor Load 3: 12 kV A at 0.8 leading power factor If the line voltage a l the loads is 208 V fillS at 60 Hz, we wish to dctcrnine the line current and the combined power […]

External link to Solved > 8-91. A cable is attached to the plate:2017513 …

# Solved > 8-91. A cable is attached to the plate:2017513 …

8-91. A cable is attached to the plate B of mass MB, passes over a fixed peg at C, and is attached to the block at A. Using the coefficients of static friction shown, determine the smallest mass of block A so that it will prevent sliding motion of B down the plane. GraduateWriterHelp.com is an online academic writing platform that provides extensive assistance to […]

External link to Solved > 4-94. Determine the maximum weight W the man:2016667 …

# Solved > 4-94. Determine the maximum weight W the man:2016667 …

4-94. Determine the maximum weight W the man can lift with constant velocity using the pulley system, without and then with the “leading block” or pulley at A. The man has a weight of 900 N and the coefficient of static friction between his feet and the ground is µs = 0.6. 4-95. The 5-kg cylinder is suspended from two equal-length cords. The end of […]

## Calculate the price of your order

550 words
We'll send you the first draft for approval by September 11, 2018 at 10:52 AM
Total price:
\$26
The price is based on these factors:
Number of pages
Urgency
Basic features
• Free title page and bibliography
• Unlimited revisions
• Plagiarism-free guarantee
• Money-back guarantee
On-demand options
• Writer’s samples
• Part-by-part delivery
• Overnight delivery
• Copies of used sources
Paper format
• 275 words per page
• 12 pt Arial/Times New Roman
• Double line spacing
• Any citation style (APA, MLA, Chicago/Turabian, Harvard)

# Our guarantees

Delivering a high-quality product at a reasonable price is not enough anymore.
That’s why we have developed 5 beneficial guarantees that will make your experience with our service enjoyable, easy, and safe.

### Money-back guarantee

You have to be 100% sure of the quality of your product to give a money-back guarantee. This describes us perfectly. Make sure that this guarantee is totally transparent.

### Zero-plagiarism guarantee

Each paper is composed from scratch, according to your instructions. It is then checked by our plagiarism-detection software. There is no gap where plagiarism could squeeze in.

### Free-revision policy

Thanks to our free revisions, there is no way for you to be unsatisfied. We will work on your paper until you are completely happy with the result.